Product weight: earrings (pair) - 6.6 grams pendant 11.8 grams
Materials
- silver earrings — 2 pieces;
- silver memory wire with small diameter is 2.5 round;
- T - shaped silver clove (Pina) — 13 units;
- silver beads — 189 pieces;
- flat faceted green glass crystals with a diameter of 0.5 cm — 56 pieces;
- oval faceted transparent beads of glass with a diameter of 1 cm 2 pieces;
- oval faceted bright green lampwork glass beads with a diameter of 1.2 cm — 3 (holes bright green beads should be wide enough for threading the stud and the two clasped each other lengths of wire).
Job description
- For the manufacture of earrings one turn of small diameter wire cutter divide into two equal parts. On the segments of wire on one side with round nose pliers make loops inside. Start stringing the beads: one silver bead, one transparent bead and six silver beads. Then placed one crystal and six silver beads. Repeat this sequence three more times. Finish the manufacturer of earring loop to the outside. The same pattern make the second earring.
- To create two options suspension kit take the T — shaped nail. Strung him: one crystal, one silver bead, one crystal and two silver beads. Did the option of a short suspension. Leave the tip of the wire size of 1.2 cm and at the end formed a simple loop. For the formation of long pendants, take a T — shaped nail and strung him: one crystal, one silver bead, one crystal, two silver beads, one crystal, three silver beads, one crystal and four silver beads. The end stud block simple loop. Just make four short and four long pendants.
- From the outer loop attachable earrings for mwense and long sling. Open loop earrings, and loop suspension tools, like a ring. Put them on the outer loop and close. In the end position shvenzy should be at the top of the loop, and the pendant at the bottom. In the same way fasten one short sling on the bottom of the inner loop. The earrings are ready.
- For the formation of the frame of the pendant on the T — shaped nail wear: one crystal, one silver bead, one crystal, one silver bead, one crystal five silver beads and one of bright green bead. A bead is threaded through the two lines equal ? the circumference of the spring wire each. Carefully align the segments of the wire so that two sides were equal directed line segments.
- On the upper part of the T-shaped stud further string four silver beads and one crystal. Block the end of the stud by a simple loop. On the top left segment of wire strung seven silver bead, one crystal, one silver bead, one crystal.
- Set block forming pliers the inner loop. Hands bend to the left side wire with beads.
- On the lower left segment of wire strung: 10 silver beads, one crystal, 5 silver beads, and one bright green beads, 3 silver beads and one crystal. At the end of the wire with round nose pliers curl the inner loop. Similarly draw the right side of the pendant.
- For making extra hangers for pendant take a T - shaped stud. Strung him: one crystal, one silver bead, one crystal, one silver bead, one crystal and one silver bead. Leave the tip of the wire size of 1.2 cm and at the end formed a simple loop. All you need to do 4 additional pendants.
- With two sides from the long, fixed suspensions additional suspension. Open loop hangers tools like ring. Put them on both sides of the long hangers on the inner loop and close. The pendant is ready.
- Try to flatten the top of the pendant. The beading should lie quite close to each other (considering the upper bends of the wire) to the design of the pendant was sustainable.
