Rose bead (+ schema)
First consider the circular technique of wire braiding which is made of twigs, butterfly and rose bead. On the right end of the wire is 50-60 cm long make a small loop, which will not allow the beads to fall. Type 6 beads on the left end of wire twist a loop more (Fig. 1). The beads move close to the loop. Enter 9 beads and loop the wire to the right of the beads in Fig. 2. That leaf turned out pointed to the left the beads lay at a right angle and the right at a sharp. For the next row, type 11 beads and wire re turn to the left, etc. (Fig. 3, 4). The more rows, the bigger the leaf. For small leaves initially, it is possible to collect 4 beads for larger 7-8. The number of beads in the next rows 2-3 beads more than the previous. When the leaf is ready, the loop to the right and loosen the wire clip from the inside of the leaf. Loop left, cut wire and twist together. Connecting the leaves, twisting them with each other - from small to larger - you can create a branch of colored leaves of different sizes. Of the same leaves (2 large ones. 2 small), but with a pattern inside, you can make a butterfly Twist in pairs, small and large wings together. Two pairs of wings connect to each other On top of them attach the body to the head, woven in Fig. 5. Rose beaded leaves are pointed, and the petals in Bud - round. To obtain the round petal wire with beads and put the left and right of the first row at approximately a right angle (Fig. 6). For Bud take 3 small petals for the flower - 2 small. 5 medium and 5 large Socket on the bottom of the Bud and the flower weave in Fig. 7 and Bud, 5 leaves, for flower 6 Wire from Bud and flower run through the middle of the rosettes. And leaves, and roses can decorate, for example, photo frames. The branch of roses and a butterfly may be used as brooches, if they are careful to attach the pins. As for the decoration of the branches themselves, then you can behave differently. Possible is necessary to select the required wire color (green, Burgundy, brown) is greatly simplified because it is not necessary further processing If this is not possible, the stem of each part before the connection tape wool or floss in the desired color, and in 3-4 additions. For this wire under the flower or Fox whoop lubricate with white glue (it dries becomes transparent) and make several turns of thread, wrapping the coils on top of each other. Let the glue dry. Then, holding the threads in the fingers not the beam, and placing one after the other in the plane as if it were a ribbon, start winding. It is advantageous not to twist the strand around the wire (then the coils will fall unevenly and loosely), but rather - fingers with a thread to keep stationary and the fingers of the other hand to twist the decorated item, stacking the coils with small overlap. In the field connection details connect the strands and continue winding. If you don't need thickening, which happens due to the increase of net threads, the excess ends cut off, but not in one place, and "scatter". Continue wrapping the stem to attach the following details. At the completion of the wire ends do not cut, and 2-3 mm Express not braided. These risers fold in the treated stem, all the grease and glue on top of back, overlap the closing turns of bare wire and stem. The thread is cut. Another way is coil of wire in corrugated paper. Paper cut a strip of width 5-7 mm and repeat the procedure described above. In the manufacture of brooches it is better to use a thin ribbon or ribbon that will give your product the sophistication.Author Yu Lyndina