Parrot common parrot with a long tail beaded

Figurines from beads in the form of a bright, talkative parrots will occupy a worthy place in your collection. They can be put side by side on a twig or even to organize a zoo. Both figures are beaded in the shape of parrots are about the size of 7 cm. Ordinary parrot bead Parrot common parrot with a long tail beadedMaterials for a parrot of the ordinary:
  • wire, diameter 0.3 mm;
  • beads of black, gray, white, red, yellow, green and blue color with a diameter of 2.5 mm
Execution:
1. Ordinary parrot bead is performed with the head. Use the parallel weaving. String beads following the pattern. The outer edge of each row of the head keep to each other so that in the end, the head was narrow shape. Parrot common parrot with a long tail beaded 2. In the 16th and 22nd rows pull additional wire segments so that two sides from the body of the parrot were the same pieces of wire to make wings. Beads for additional rows of string from one side only of the wire. This end of the wire is thread through the opposite edge of the previous row of beads and pull it through the whole series. A series of beads lay parallel to the preceding row. When you weave flat wings, give them the desired shape - the photo of the parrot flaps her wings. 3. 25-th and 29-th number of interweave otrezochki wire - these will be the legs of a parrot beaded. Immediately interlace the foot. 4. To perform the feathers in the tail of the stretch in the last row of the body of a bird three additional orresokka wire. In the 5th number of each of the two parts of the tail, add another trasacco wire to give the similarity of the shape of feathers. Parakeet beaded Parrot common parrot with a long tail beadedMaterials for long-tailed parrot:
  • wire, diameter 0.3 mm;
  • beads of black, anthracite, white, polished white, orange, orange, beige, bright blue, green and Apple-green color with a diameter of 2.5 mm
Execution:
1. Parakeet similar to ordinary woven from the head. Follow the shape of beads, following the below scheme. Interweave an additional fifth row the same as described in paragraph 2 to the parrot of the ordinary. 2. In the 12th row, for further better preservation of the shape of the wings, highlight the Central bead. Through it and the next 13-th number thread a piece of wire that will be attached to the wings wings. 3. In 23-th and 25-th rows thread the additional wire - this will be the base for legs. The ends of the wire must be the same on both sides from the body of a parrot. In the 46th number of thread the extra wire for the tail. Tip: while braiding the wings to string the beads you tightly. When you need to form the wings of the arch — see photo. In this case, the wings will fall more closely to the body of the bird bead. Parrot common parrot with a long tail beaded

Add comment

Security code
Refresh