Card No. 4
You'll need:
a piece of copper wire of 30 cm in length;
two glass beads light brown
colors: 1 5 mm (for head), 1 with a diameter of 7 mm (for the body);
— 12 beads brown color with a diameter of 1.8 mm.
The manufacture of the spider, start with the eye. Take a piece of wire and bend it in half. On one end nanigi one bead and slide it to the middle wire diagram 4
The thumb and forefinger of the left hand grasp the bead, and the fingers of the right hand hold the wire ends close to each other as shown in diagram 4
To the bead-eyes were easy to place on the head of a spider, you need to twist a small section (3-4 mm) of wire above the bead. Not releasing the bead from his left hand, his right hand pinch both ends of the wire at a distance of 5-6 mm from the bead. His left hand twirled the bead myself, making five or six turns on the section of wire between biserinki and fingers of the right hand diagram 4
Right hand slightly togni one end of a wire and nanigi the second bead. Place it on a distance of 5-6 mm from the end of the twisted plot diagram 4
The fingers of the left hand you hold the bead in the place of wire, and the right hand bend the wire end as shown in diagram 4
Now we need to secure the second bead in this wire. Fingers of the right hand hold the end of the twisted sections together with a bent wire diagram 4
The fingers of the left hand, take the bead and make five or six turns from himself, twisting the section of wire between the bead and the fingers of the right hand. The eyes of a spider ready scheme 4 .Twisted sections of the wire make the eyes more expressive and place them on the head. Now, attach the eyes to the head. To do this, get together and align both ends of the wire diagram 4
Nanigi them bead smaller (the head) and move it close to the twisted plots. Part of the twisted wire is included in the bead diagram 4
Kindle wire with the beads in different directions, and put the bead eyes on the surface of the beads diagram 4
On both ends of the wire nanigi the bead and place it close to the bead diagram 4
Make eight legs of a spider, four lapkis each side. For this nanigi on the left end of wire a single bead. Hold her at a distance 1.2 cm from head diagram 4
Holding the bead in this wire with the left hand, right togni the end of the wire as shown in figure 4
Plot twist the left foot. For the right foot nanigi the bead on the other wire and place it at a distance of 1.2 cm from the head of the spider. Bend the wire diagram 4
Spin the wire to secure the bead diagram 4.
Two loose ends of wire to twist together with one or two turns. It will not allow the feet to fall apart diagram 4
Repeating the techniques, shown in figure 15-19, do it six legs — three on the left and right.
You can now attach the torso. Nanigi on both ends of the wire large bead and move it close to the paws scheme 4. Secure the bead, the trunk on the wire through the last bead. For this nanigi bead on one wire end. Without moving her close to the bead, skip the second end
wire through the hole of the bead in the opposite direction of scheme 4. Tighten the ends so that the bead is close to the bead body.
The remaining ends of the wire twist between the area of 3-4 mm. cut off Excess with scissors. Togni twisted plot down under the bead diagram 4