For its production will need :
1. beads green color No. 10 , 40 - 50 grams.
2. wire 50 cm thick aluminum, and a coil of thin white.
3. alabaster (gypsum building plaster)
4. thread or floral tape
5. duct tape
6. pot for a tree (I used the candle in this pot was a candle before)
7. PVA glue
8. pebbles or coarse sand
9. side
The beads pour into a flat container, from it we will be stringing beads onto the wire.
The wire cut into pieces of 30 cm, will need 120 pieces For the barrel take a thick wire for 40 -45 cm in length, you will need 3 pieces of Formed branches: on thin wire will get 70 beads beads, wire fold in half , dividing the beads equally on each side. Make a loop of 7 beads between the hinges leave a distance of about 0.3-0.6 cm and Then twisting the wire and get 1 stick of it.
When finished all 120 pieces, assemble the wood.
Taking them 2-3 sprigs of wire and begin to wrap the trunk of the branches with string or floral tape if you want a bigger tree, increase the number of branches to 5-6. Such twigs make 24 pieces.
Now do larger branches of 4-5 branches. Wind 2-4 cm thread or floral tape.Begin to collect the tree. From thin branches twisting and winding wire make 3 to 4 large branches. They, in turn, attached to a thick wire (the trunk) and wrapped with electrical tape for 5-6 cm on Top of the electrical tape wrapped with thread or floral tape. Align is the thickness of the trunk. Then 3 large branches attached to a thick wire connect together forming the barrel.
The diagram shows Assembly, vertical (tree trunk) is a thick aluminum wire.Each small branch (consisting of 2-3 or 5-6 sprigs) 24. The wire should be 4-6 cm (roots) they will then hold the tree in the soil (the gypsum). The cast half of the glass pours into a plastic container and add water, knead quickly, consistency as sour cream. Tree put in a pot and fill with plaster, not in a hurry, so as not to stain the trunk of the tree.
Leave for a few hours. When the plaster hardens the barrel and covered the ground with white glue. The glue spread pebbles and coarse sand. The glue dries, it becomes transparent. After 4 hours again cover the clay basal space of the tree and if any of the pebbles flew off glue.
So that the glue "grabbed" you need a few hours.
You're done! Enjoy the result.