Under this scheme, the beading is lagging most of the jewelry: necklaces, bracelets, bracelets, belt... Especially often this scheme is used in a variety of collars.
The mesh can be made of beads or their combinations to the cabin, with glass beads, using beads - possible variants of combinations of thousands, here the only limitation is your imagination.
Below is a simple weave pattern mesh - only used beads. So, type on a thread eight of the beads and sign in the 7th, as shown in the figure. Pull the thread. Type 3 beads and enter into the fourth bead and tighten the thread. Again, type 3 beads and go through bead 1. Continue beadinguntil you reach the desired length of the product.
Product woven from beads specifically for this scheme, it is best to look great as bracelet bracelets or jewelry like a collar on the neck. You can not gain the bead number 8, and collect the beads 5, 6, 7, 9, 10, 11 and to push the needle through bead 4. On top to do the same thing - then the product will work without jagged edges. You can also experiment with the number of beads in the loops of our mesh, or use glass beads and cutting (for example, instead of the beads 9, 11, 12, 14, etc. to paste cut). However, be aware that cutting and glass beads are the sharp edges - they can cut the thread. Therefore, you should not use them as retaining beads (in the diagram, beads №1, 4, 7, 10, 13 etc.).