Today we will make another bracelet with these wonderful beads that have two holes. From the very moment of his appearance they were interested in bead needle, which tried to combine them with other types of beads. And now, your attention is invited to the result of such surveys. Bracelet with tila beads.
We'll need beads of two sizes – 11 and 6, can take slightly smaller – 8, tila beads and monofilament.
Strung on a thread of blue bead No. 11, leaving a small tail for the formation of fasteners 3 bright beads, 3 blue, 4 light, 2 beads No. 6, and again 4 and 3 light blue. Lock it all in the ring, sending the needle in the first 3 strung bright beads.
Next, string 1 light bead, tila bead, 4 light beads and 3 blue. And send all that low in 3 bright beads as shown in the pictures.
Then again strung on the thread of the first combination, but in a somewhat reduced form. 1 light bead, 2 beads No. 6, 4 light, and 3 blue. And put the needle in 3 bright beads of the previous step. Look at the picture, so it will be clearer what and where it should go.
Repeat the step with the bead tila. It will be exactly the same as described above.
Form a chain of necessary length, and begin to weave an openwork bottom row of beads.
Look at the first line of our upper tier, and the accuracy is repeatable. It turns out that such a billet.
Add it to our first row by inserting the thread into the second hole Tila.
Light string 4 beads, 3 blue, and send in 3 bright beads of the previous step.
Repeat these steps until the end, until the end of the upper side. It remains only to formalize the clasp, the new bracelet is ready.