Material:
8 medium-sized blue beads (3-4 mm in diameter) and 14 small blue beads (2-2. 5 mm in diameter) for dragonfly; 3 yellow and 3 green beads for flowers (3-3. 5 mm in diameter); fine chopped beads (n 9/0) — 5 g green 5 g of white, beige 3 g, 2 g of pale pink and 1 g of bright pink; fine copper wire; the green and beige thread to match the beads; PVA glue; box and carton, covered with velvet paper or plain cloth.
The size of the beads used in the manufacture of models, numbered in accordance with the Czech classification: the smaller the bead, the bigger the room (figure 1).
Job description:
To make an oval leaf, take a piece of wire of 15-20 cm put the First bead in the middle of the wire. Dial on one end of the wire two beads, then thread them through the other end towards the first (figure 2A). Beads of the next row dial on one end of the wire, thread the to meet him the other end (figure 26), and so on. Wire pull to the ranks tightly to each other. Having finished the paper, the ends of the wire slightly twist (figure 2B).
Other elements of the bouquet follow this way. The figure shows the scheme of a narrow sheet (image), flower petal (figure 36) petal Bud (figure Fi).
Prepare six petals for the flower of white, light pink and hot pink beads. For each petal have 25-30 cm of wire. String on the wire length of 10-15 cm is a small yellow bead to the middle of it. Fold the petals and the center flower. All wire ends of the petals and midway connect and tightly twist. On the stalk, put the green beads close to the petals and make a Cup of flower.
Follow these 4 petal for a little Bud (for each petal take 20-25 cm of wire). String on the wire a small bead to the middle of it. All wire ends of the petals and midway connect and tightly twist. On the stalk, put the green beads close to the petals. The second Bud do the same, but of five petals.
Three oval leaves connect to the branch. Lubricate the stem with glue and tightly wrap the green thread turn to turn, so the wire was not visible.
Attach to the stalk of the large Bud single oval leaf and on the stem of the small Bud — two oval leaves. Lubricate the wire stems with glue and tightly wrap the green thread.
Broom weed, run from beige beads (figure 4). Take a piece of wire length of 20-25 cm String on 4 beads. Slide the last bead, and thread through the other end of the wire in the opposite direction (figure 4A). The resulting suspension position approximately in the middle of the wire. Keep nisana panicle scheme (figure 4B,C,d). After the broom, the ends of the wire tight twist. Run a long piece of beige bead (see figure 3). Attach it to the stem of the panicle. Brush wire stem with glue and tightly wrap beige thread.
All "plants" gather in a bouquet.
To make dragonflies four wings of white beads (figure 5A). Four medium-sized blue beads to string on wire (figure 56). Through two beads and pass the wire end back. To extreme busine attach the two wings (figure 5B). String on the wire ends a small bead and attach to it the following two wings. 6 string of small blue beads and secure the last bead (figure 5g). All wire ends are possible in the next thread beads on the torso and wings. The remaining tails cut off.
Figure 4
Figure 5
Bouquet and a pair of dragonflies clip invisible stitches on the cardboard and insert the composition into the frame.