The Poltava surface used in the bilateral embroidery with floral pattern, where it is necessary to perform the stitches with a length of more than 1 cm do it from left to right and very tight. The fabric is not seen through the embroidery. The stitches in this kind of surface do of 1-3 cm using the Poltava surface fill large areas of the pattern. Every stitch that he did not depart from the fabric, fixed in addition a small diagonal stitch.

Doing it this way. On the front side of doing long stitches. Inject the needle to the right and withdrawn from the inside of the left side and below the stitch 3-4 mm. Pull the working thread. Then make an additional securing stitch diagonally over a long stitch and remove the needle at the beginning of a long stitch. All other stitches are carried out in the same way. Usually they are placed parallel to each other and on the same level, so that the stitch was beautiful. If a long stitch is 2-3 cm, then you don't do 1, 2 or 3 additional diagonal stitch.

The round flowers embroidery starts from the middle of the flower and have stitches in a circle, as in a conventional two-way. So stitches radiate from the middle like rays. If you want to rotate the stitches, repeating the shape of a flower, first you make a long stitch, then short and long again. Then all stitches are fixed from the top diagonal stitches additional. The leaves perform parallel stitches.

Before operation, check to shed thread or not. Why do several stitches on white fabric. Then wash it and Pat. If the thread shed, a fabric around the stitches will be painted.

Add comment