When selecting pattern for embroidery, you should consider the purpose of the product and the quality of the fabric. For example, for stitching thick fabrics should be chosen large pictures and is more suitable for thin fine pattern.
Beads, glass beads, sequins should be stored in small tightly sealed boxes, jars, vials, pre-arranging them by color and size.
There are several ways to transfer the pattern on the fabric. This is a translation of drawing through carbon paper, priporashivajut and obstacle.
Fabric is required to spread on a solid flat surface faceup, to note on it the location of the pattern, the motif is transferred to tracing paper. What the tracing paper with the pattern placed on the fabric and fix with pins, under it enclose a carbon paper and pencil tracing all of the contours of the figure.
All lines should be thin, and the same is to trace several times, as traces of carbon paper is very difficult to wash out. So, if you have a new sheet of transfer paper before to start to use, it is advisable to wipe it with a cotton swab. Remember that purple blueprint does not use.
If carrying a drawing on the wrong side, it should be converted in mirror image to the front side he had not turned upside down. In this case, the table need to put a blueprint on her fabric face up, and the fabric pattern. Then the contour drawing gotta go steam on the reverse side, and turn to the Hoop on the front side.
If the picture is to be put on dark fabric, it is better to use yellow carbon paper or a dry soap or tailor's chalk. To do this, the wrong side of the figure, you should grate the soap, or chalk to transfer the pattern without using carbon paper.
On shiny fabrics, velvet and cloth figure, usually translated by obstacle. At first transfer it on tracing paper that you want to pin to the front side of the fabric and tuck in the Hoop. Gotta go steam then drawing the contour and remove the tracing paper.
This way you can take a pattern and knit or thin fabric, using the interlining, to remove which is not subsequently necessary.
On thin fabrics the pattern was transferred using glass and light. This glass is placed over a light source, put on his cloth, fastened with drawing pins and drawing contours encircle with a pencil.
The tracing pattern is necessary to put on a soft cloth, then take the awl holes along the contour of the pattern, and then with sandpaper. Next, the figure put on a cloth and wipe along the contour with a cotton swab dipped in a special solution. For dark fabrics you will need to mix 0.5 cups of kerosene with 2 tsp of chalk for light fabrics instead of chalk, use tooth powder. The coloring composition through the holes penetrated the fabric, so it will remain a point.
Embroidered dress or blouse with a symmetrical pattern you can put it on 2 parts at the same time. Why you need to fold the fabric in half, right sides out. Then the top and between the layers of fabric to put the carbon paper and pattern and reshoot it with a pencil. The figure is translated symmetrically into 2 parts in a mirror image.
In this method, the pattern is not distorted, even if it is used multiple times. After applying the tracing paper with a picture should be washed with kerosene, dry and clean.