The upper section of the skirt is traditionally handled waistband or facing. Processing upper edge of the skirt belt shown in the scheme:
Treatment of the skirt: waist
Treatment of the skirt: waist
Designations on the scheme: From the main fabric And the front panel of the skirt; B - belt; gasket material:- gasket of the belt.
The processing sequence of the upper edge of the skirt belt shown in the table: № designation technologically indivisible operations specifications Sketch 1. To duplicate a zone of an adhesive strip on the reverse side, aligning the middle of the belt with the cut strip

Treatment of the skirt: waist

2. To oblachat belt at the ends of the sh. sh. 0,5 - 0,7 see the end of the transition zone on the side of the grind is also a seam width 0.5 - 0.7 cm, and the lower cut - seam width of 1 cm.
Treatment of the skirt: waist
3. Trim the seam allowances grinding belt, Not to line 1.5 mm
Treatment of the skirt: waist
4. Remove the belt on the front side of the Straightening corners
Treatment of the skirt: waist
5. Priotity belt From podmotsa through protohellenic moisturizing, bending it along the length of 6. To pritchet waistband to the skirt, right sides folding inward, equating sections, sh.sh.1 see the seam protecive belt on the front panel, not reaching the side seams about 2 cm, put hangers. The length of the hangers in finished form 6-12 cm

Treatment of the skirt: waist
7. To press the seam allowances protecive belt In the direction of the belt 8. Topstitch the second longitudinal section of the belt at upper edge of skirt, Turning it inside out by 0.8-0.9 cm, overlapping the stitching seam primaqiune the waist to the skirt, sh.sh. 1 mm
Treatment of the skirt: waist
9. Priotity belt in finished form Through the moistening protohellenic
One of the criteria of the quality belt is the same width throughout its length. To improve the quality of processing by injection molding zone, setuipanel his crease and pulling the sections to primaqiune to the skirt.
For products made of thick fabric, the inner longitudinal cut belt overcast before you attach the waist to the skirt, and fix a line laid in the seam protecive belt:
Treatment of the skirt: waist
In the case of the notched upper edge of the belt it cuts out 2 parts with grinding tips and top cut for a given circuit:
Treatment of the skirt: waist
In the case of using two needle machines and special devices (for example, in denim skirts) possible treatment option presented on the figure below :
Treatment of the skirt: waist

Add comment