Double swag with bell

Construction:
1) draw to the fold of the fabric perpendicular, on which lay off the magnitude of AB = 25 cm + aa1 (7 cm for processing) + the value DB1 (1/2 the width of the bell is 12 cm) = 44 cm
2) In the crook postpone д1д = 20 - 25 cm (depends on kopiruem spine tissue)
3) From point b hold down the perpendicular = magnitude д1д + 3 (5) cm (to the processing of pleats and bell) BB1 =DD1 + 3(5)cm drive1 - section
4) From point d to hold the bend angle, which is delayed 1/2 of the width of the bell
DB1 = GD (4 + 8 = 12 cm)
5) At the fold point D1-delayed value of W with k (2) point T; T = 0.45 x 2 = 0.90 m; with k (1,8) - 45 x 1.8 = 81 cm
6) From point T hold perpendicular to the bend
7) From point d pushes the value of the bell l (0,40)
8) From point T up and hold an arc, equal to the amount of ve(sketch, obtained by measurement) = 1/2 magnitude lower SAG + 1/2 the width of the bell 80 + 16 = 96
ve - expected cut of Smad
9) Connecting the dots in a1, the resulting Smad with a shoulder k on the build-draped folds.

Double swag with bell

 

AB - shoulder double-Smad (30 cm)
BV mid - Smad (30 cm)
CE - the height of the bell (40 cm)
ee1 - 1/2 the length of the lower edge of the bell (14 cm)
ае1 - 1/2 length of lower SAG (78 cm)
в1с - 1/2 the size of draperies (25 cm)
BB1 - 1/2 glubiny the top of the bell (10 cm)
h - the height of the bell (50 cm)

This model can be implemented in warp

 

Double swag with bell

Add comment

Security code
Refresh