Typically, in the manufacture of frame elements there is a need to extend the working of the straw, as it is long enough only to carry small items with a side of 1,5—2 see
1. To extend the working of the straw to select a new straw of equal diameter with the ending.
2. Old working a straw cut at an acute angle with the outside of the frame (figure 5.61).
3. The thin end of a new working straw lightly dip in PVA glue and insert into hole ended straw. New straw should snugly fit in the hole, and if the end is too thin, a little trim it.
4. Continue stitching nastavlenii culm. The junction will close the round and will not be noticeable.