Scan of a flower cut out of white or light skin medium thickness and softness (figure 79). It is 6 stamens, cut strips with a width of 7-8 mm, glued in half across the length. Each stamens of a brown suede or leather cut out boot. Cut off one end of the filament diagonally, fold the piece of anther in half and glue at the end of the stamens. If the part of the boot cut from leather, it is necessary to glue the flesh side outwards (figure 79 a, b, C, d).
Ready stamen bundle in the middle, insert the end of the branch-stem and glue. Before gluing tape the stamens to the stem threads, the color of which is close to the color of the skin.
Unfolding the petals soak in a solution of PVA glue and give them natural curves, averting her petals out. Let the details dry.
Refine, servuice edge connecting the valve and the area opposite the edge of the pattern, where it will be pasted. Grease glue the base of the stamens, wrap around it a sweep of the petals and glue it with a valve.
Now with a utility knife carefully cut the excess thickness formed at the junction of the flower and the stem. The excess skin is cut on a cone, which creates a smooth transition of the Corolla of the flower to the stem. Connection mask a strip of thin leather or suede color Lily petals, spirally winding a strip fixed from the flower to the stem (figure 79, d,e). Secure it on the stem after one or two turns. The junction of the touch up, achieving a smooth transition of color from the stem to the flower.
Lily leaves join the stem a little bit differently than other colors. Parts of leaves cut out and servuice blunt end. Cut the ends to the base sheet, apply glue and stick, them clasping the stem on both sides (figure 79, W, z). The sheet should be placed perpendicular to the stem. Ensure that the ends of the leaves were sent to the parties at different angles. Touch up the attachment of leaves to the stem.
