Rolling pins cuff is constructed identical to the cuffs, just on the outer edge to build the mesh with filigree second PA - Roy in the outer region. Filigree propitaetsya polotnyanko, extreme equity pair in Perevi (figure VIII.30). In the center of the cuff — platescope filling to form squares. Collar build first bars, and then keep adding to it the mesh to the outer edge and sew in polotnyanko of the collar. Plotting points pinhole in the mesh and polotence identical to the construction in the cuff.
Zaplet start in an inconspicuous place. In the cuff zaplet start with the corner with the mesh. Do it, and then, throwing filigree, continue to perform polotnyanko.
Grille platescope filling can be performed in two ways: in the first case, a pair of polotnyanyi after his execution, go to execution of Plachkov, and in the second case, the system first lining, and then separate the pairs are mounted to run platescope filling and sutured to polotnyanko.
You can complicate the collar close to the mesh, through a series of squares platescope fill polotnyanko. Only when you build to consider that the lattice of the General background and the individual squares must be the same, and when you build on the corners of the mesh and polotence point pinhole inner edge of the mesh closer together. Accordingly, these nikolam squares platescope filling curves also converge. Coupling mesh with the internal polotnyanko possible the place of its connection with polotnyanko collar.