Treatment of trousers: side pockets on the front parts of the halves of the pants

Side Welt pocket in the frame on the front part of the trousers can be processed vertically, inclined , rarely horizontally:

The processing circuit indicating the details of the cut is shown in figure:

Designations on the scheme: From the main fabric: A - front half of the pants; B - the back half of trousers; The upper facing; Mr.; lower facing; D - valance; made of lining fabric - lined pocket.
The processing circuit indicating the execution order of the lines, trapped in the cross-section:

The processing sequence of the pocket is represented in instructional technology map: № p/p the Name of technologically indivisible operation THAT Sketch 1. To identify the location of the pocket on the front part of pants, Four lines on the front side

2. To baste the pocket lining to the front of the pants for Adjusting the upper cut, stacking from the inside with a length of 1.5-2 cm outside the side the chalk line a running straight stitch at a distance of 1 cm from the planned lines

3. Neaten the inner facing on the front side on the inner slice

4. To press the piping along the Folding right side out, side in half and the inner 1/3
5. Neaten the valance On the inner and lower cut on the front side

6.To pritchet piping to the front piece of the pants stacking bends to the planned lines, symmetrically relative to the side of the planned lines, starting and ending stitching at their level, sh.sh. 0.5-0.7 mm

7. To check the quality of the previous operations From the lining of the lines must be parallel, must begin and end at the same level
8. To cut the pocket in the Middle between the lines, not reaching lateral lines 1 cm, cutting Napoli before reaching the thread lines 1 mm

9. Remove the piping On the wrong side

10. Priotity pocket on the front side, through protohellenic
11. Pin the corners of pockets Triple reverse stitching at the base of the area, by bending the front part of the pants, nastraivat on obtachku

12. Topstitch inner facing on the lining of the pockets by bending the front part of the pants, the inner cross-sections, sh.sh. 2-3 mm
13. Topstitch the valance on the lining pocket by Equalizing the side and top sections, sh.sh. 2-3 mm

14. To pricecat the valance and lining of the pocket to the allowances of the side seams primaqiune piping to the front of the pants To the seam primaqiune, capturing part of the lining of the pocket, by bending the front part of the pants, at the same time grinding off the lining of his pocket sh.sh. 1 cm

15. Neaten allowances of seams in stitching lining pocket
16. Priotity pocket

Add comment